From a single repair to a full AMC plan, our technicians carry the parts and tools to sort most jobs in one visit — with a written quote before anything is charged.
Full diagnosis and repair for units that have stopped cooling properly, are leaking water, or making unusual noise — with the fault explained in plain terms before any fix begins.
Split, window, tower and cassette AC installation with secure, vibration-free mounting and correctly sized copper piping for reliable long-term cooling.
Leak detection followed by full vacuuming and refrigerant top-up, with a pressure test afterwards to confirm the fix holds under real load.
.png)
Jet-pump filter wash plus condenser and coil cleaning to strip away dust build-up that quietly drags down cooling performance and raises power bills.
Concealed piping, extensions and replacements sized to the correct gauge, protecting cooling efficiency and preventing future leak points.
.jpg)
Safe gas recovery and careful removal when you're shifting homes, replacing an old unit, or putting your AC into storage.
Scheduled visits across the year with priority booking in peak season, so small issues get caught in an inspection report before they become breakdowns.
A root-cause check for weak airflow, warm air, or a unit that short-cycles — going beyond a filter clean to find what's actually limiting performance.
Component-level repair for the parts that actually break down — compressor faults, PCB failures and fan motor issues — diagnosed and fixed on-site where possible.
Tell us the issue, your AC type and preferred time — online or over WhatsApp.
A technician runs a full diagnostic at your doorstep and explains what's wrong.
Work starts only after you confirm the written estimate — no surprises later.
The unit is repaired, cleaned and tested for cooling performance before we leave.
We don't run a flat rate card, because no two AC jobs are the same. These are the things our technician actually weighs before writing up your quote.
Window, split, cassette and PAC/duct units each need different labour, tools and parts — so the same job can carry a different price depending on what's on your wall or ceiling.
A quick visit and inspection costs far less than a wet jet-pump deep service, a full installation, or component-level work on a compressor, PCB or fan motor.
Extra copper piping, insulation, electrical wire, communication cable and drain pipe are measured at your home and charged by the metre — never estimated in advance.
Genuine spares, wall brackets and fitment charges are added only where a job needs them, and are always shown separately from labour on your quote.
Shifting a unit — dismantling it, moving it, and re-installing it elsewhere — is priced as its own step, distinct from a straightforward new installation.
If your unit or a past repair is still under warranty, that's factored in before the final number is written — you're never billed for work that's already covered.
No fixed catalogue pricing — every quote is confirmed after inspection. Here's what each plan covers.
For a single repair, install or cleaning job.
Scheduled maintenance across the year, homes or offices.
For breakdowns during Hyderabad's peak summer heat.
A technician inspects the unit first — checking the AC type, what work is needed, and whether any piping, wiring or parts are involved — then gives you a written quote covering labour and parts. Work only begins after you approve it.
We're an authorized service center for Hitachi and Onida, and we also repair, install and maintain every other major brand — including Daikin, Carrier, Samsung, LG, Blue Star, Voltas and Lloyd — as a general service provider.
Scheduled maintenance visits, priority booking during peak season, and an inspection report each visit so issues are caught before they cause a breakdown.
Yes — our technicians install and uninstall Split, Window, Tower and Cassette units, including copper piping and outdoor unit mounting.
Yes, we handle homes, offices and commercial installations, and offer AMC plans suited to multi-unit sites.
